The ALC0300 comes as an open frame unit making it easy to integrate into a wide range of product from active speakers through to
home audio products.
The module is based on a phase shift modulated topology with advanced protection circuitry. This topology shows very low distortion figures and because of its simplicity and robustness the finished products are very attractive both when it comes to functionality and cost.
The power supply is inherently designed for ultra low noise making it well suited to the demands of audio and consumer electronic products. It also delivers +/- supplies to an external PCB, for example a cross over board or pre amplifier board in a dual mono integrated amplifier.
The built in over current protection has two modes. During transients into the current limit threshold it allows constant output current but if this condition persists it goes into burst mode. This guarantees that the amplifier does not create audio holes during heavy listening but still effectively protects it during short
circuiting.
The thermal protection contains a sensor connected to the very tab of one of the output devices giving a very fast detection and shut down should over-load occur.
A connector kit for the ALC0300 is available here